Youtube
Youtube
How to Repair a Broken Interior Door Handle on a Toyota Tundra
Introduction
Having a broken interior door handle on your Toyota Tundra can be a major inconvenience. It can make it difficult to get in and out of your vehicle, and it can even be dangerous. Fortunately, replacing a broken interior door handle is a relatively easy and inexpensive repair that you can do yourself.
Step-by-Step Instructions
1. Remove the Door Panel
The first step is to remove the door panel. This is usually done by removing a few screws and then gently prying the panel off. Be careful not to break any of the clips that hold the panel in place.
2. Locate the Door Handle Linkage
Once the door panel is removed, you will need to locate the door handle linkage. This is a small metal rod that connects the door handle to the door latch. The linkage is usually located in a keyhole-shaped slot on the back of the door handle.
3. Disconnect the Linkage
To disconnect the linkage, simply move the linkage sideways and pull the end of the linkage through the round part of the slot. Be careful not to damage the linkage.
4. Remove the Broken Door Handle
Once the linkage is disconnected, you can remove the broken door handle. To do this, simply unscrew the two screws that hold the door handle in place.
5. Install the New Door Handle
To install the new door handle, simply reverse the steps that you used to remove the broken door handle. First, screw the new door handle into place. Then, connect the linkage to the new door handle. Finally, reinstall the door panel.
Conclusion
Replacing a broken interior door handle on a Toyota Tundra is a relatively easy and inexpensive repair that you can do yourself. By following these simple steps, you can get your door handle working again in no time.
Komentar